CuSn11Pb2-B ( CB482K )
| Grade : | CuSn11Pb2-B |
| Number: | CB482K |
| Classification: | Copper-tin alloy |
| Standard: | EN 1982: 2008 Copper and copper alloys. Ingots and castings |
| Equivalent grades: | Go here |
Chemical composition % of grade CuSn11Pb2-B ( CB482K )
| A suffix -B is added to the designation to identify material in the form of ingots |
| Fe | Si | Mn | Ni | P | S | Al | Cu | Pb | Zn | Sb | Sn |
| max 0.15 | max 0.01 | max 0.2 | max 2 | max 0.05 | max 0.08 | max 0.01 | 83.5 - 86.5 | 0.7 - 2.5 | max 2 | max 0.2 | 10.7 - 12.5 |
Mechanical properties of grade CuSn11Pb2-B ( CB482K )
| Rm - Tensile strength (MPa) (GS) | 240 |
| Rm - Tensile strength (MPa) (GZ) or (GC) | 280 |
| Rp0.2 0.2% proof strength (MPa) (GS) | 130 |
| Rp0.2 0.2% proof strength (MPa) (GZ) or (GC) | 150 |
| A - Min. elongation at fracture (%) (GS) or (GZ) or (GC) | 5 |
| Brinell hardness (HBW): (GS) | 80 |
| Brinell hardness (HBW): (GZ) or (GC) | 90 |
Equivalent grades of grade CuSn11Pb2-B ( CB482K )
Warning! Only for reference
| EU EN |
Germany DIN,WNr |
||
| CuSn11Pb2-B |
|
Casting process
| GS | Sand casting |
| GM | Permanent mould casting |
| GZ | Centrifugal casting |
| GC | Continuous casting |
| GP | Pressure die casting |
Material conditions
| R | Material condition designated by the minimum value of tensile strength requirement for the product with mandatory tensile strength and elongation requirements |
| H | Material condition designated by the minimum value of hardness requirement for the product with mandatory hardness requirements |
Mechanical properties
| ReH | Minimum yield strength / Mindestwert der oberen Streckgrenze / Limite d elasticite minimale |
| Rm | Tensile strength / Zugfestigkeit / Resistance a la traction |
| A | Minimum elongation / Mindestwert der Bruchdehnung / Allongement minimal |
| J | Notch impact test / Kerbschlagbiegeversuch / Essai de flexion par choc |
|
CuSn11Pb2-B ( CB482K ) Copper-tin alloy |
