Gnee Steel (Tianjin) Co., Ltd.

H62 vs H65 Brass: Composition, Properties and Selection

Jan 12, 2026

Introduction to the Two Grades

H62 and H65 are both copper zinc alloys defined in the Chinese standard GB/T 5231, differing mainly in their copper content. H62 contains 60.5 to 63.5 percent copper while H65 contains 64.0 to 67.0 percent copper, with zinc as the balance in both cases. This relatively small difference in composition changes the phase balance of the alloy and has a measurable effect on ductility, corrosion resistance and forming behavior.

Composition Comparison

The higher copper content of H65 increases the proportion of the ductile alpha phase at room temperature. H62, with less copper, contains a significant amount of the harder beta phase. Impurity limits are similar for both grades, and both can be supplied with small lead additions for improved machinability when required.

Mechanical Property Comparison

In identical tempers, H62 is slightly stronger and harder than H65. Half-hard H62 typically shows a tensile strength about 10 to 20 MPa higher than H65 in the same condition. Conversely, H65 provides higher elongation and better bending performance. For parts that carry mechanical loads, H62 gives a small strength advantage, while H65 is favored where forming dominates the process.

Forming and Fabrication

H65 is the better choice for deep drawing, severe bending and spinning because its higher alpha content delays cracking and reduces springback. H62 can still be deep drawn in the annealed condition but is more sensitive to tool radii and lubrication. Both grades weld and braze well, and both are easy to electroplate.

Corrosion Resistance

H65 offers superior resistance to stress corrosion cracking and dezincification in mildly aggressive environments because of its higher copper content. H62 is acceptable for indoor and general atmospheric service, but H65 or inhibited grades are recommended for hot water, coastal atmospheres and contact with foodstuffs.

Selection Guide

Choose H62 for fasteners, turned parts, hardware and structural components where strength and cost matter most. Choose H65 for deep drawn shells, bellows, radiator fins, instrument parts and decorative items where formability, surface quality and corrosion resistance are the deciding factors. When in doubt, H65 provides a wider processing window at a modest price increase.

Frequently Asked Questions

Which grade is stronger, H62 or H65? H62 is slightly stronger and harder in the same temper because of its higher zinc content and larger beta phase fraction.

Which grade is better for deep drawing? H65 is better for deep drawing and severe forming because its higher copper content improves ductility and reduces cracking risk.

Are H62 and H65 interchangeable in production? They are not direct substitutes; changing grade requires re-verification of tooling, springback compensation and final mechanical properties.

Does H65 cost more than H62? H65 usually costs a little more because copper is the most expensive component and H65 contains more of it.

Which grade resists corrosion better? H65 resists dezincification and stress corrosion better than H62, making it preferable for water contact and coastal environments.

goTop