


General requirements for chemical cleaning: remove wax, oil, and other adherents on the surface of the fittings; remove the slight oxidized skin and slight rust on the surface of the copper fittings.
Chemical cleaning solutions are provided by the supplier on a regular basis with a warranty, and to ensure that the cleaning agent is effective and environmentally friendly. The rinsing tank for clean water rinsing uses a flat overflow method, and there needs to be enough water flow to facilitate the discharge of grease on the surface of the water. Each cleaning step uses a process-independent tank. Chemical cleaning waste disposal must comply with environmental protection regulations.
Process: Preparation, chemical degreasing, hot water rinsing, pickling and brightening, water rinsing, drying, passivation, hot water rinsing, drying, drying.
Chemical degreasing: ultrasonic tank heated to boiling, add degreasing spirit, boiling for more than 2 minutes; fittings to be completely submerged below the liquid surface in the tank, to avoid air inside the tube; immersion process, at least left and right to rotate the basket twice, so that the fittings in the cavity of the solution is constantly replaced; chemical degreasing until the surface of the fittings are completely wet by who; at any time will be the tank on the surface of the liquid oil floating withdrawn.
Hot water rinsing: the fittings will be immersed in the water temperature of 80 ℃ water tank for 1-2 minutes, turning and gently lifting the basket a number of times to remove the residual solution of de-oiling spirit. The water should flow to renew.
Pickling and brightening: Pickling and brightening using professional vibration cleaning equipment; cleaning with abrasive particles for stainless steel disc-shaped particles; cleaning volume according to different specifications and product size decisions, a basket to two baskets; cleaning solution according to the formula requirements, cleaning agent, brightening agent 1:1 ratio; matching good cleaning solution each time to join the 0.5L; cleaning time by the cleaner according to the color of the product to decide the products show the color of the original copper or whitish bright color is appropriate.
Rinsing: turn and gently lift the basket no less than three times to ensure that the surface of the pipe fittings cleaning agent residue rinsing clean, drained and dried after shaking the machine dry.
Passivation: passivation agent and water ratio of 1:15, water temperature of 60 ℃, soak the fittings completely immersed. Immersion time of not less than three minutes, every half a minute to turn and gently lift the basket once, each basket not less than three times to ensure that the reaction is sufficient.
Hot water immersion: passivation after draining the basket; put the water temperature of about 80 ℃ hot water immersion, the passivation of the residual liquid wash; fittings passivation treatment, if it does not affect the subsequent processes or fittings use, the class omitted hot water rinse.
Drying: fittings poured into the tray, oven drying, temperature 100-120 ℃, 5-8 minutes.
Maintenance: after chemical cleaning of the pipe fittings after inspection, placed in a clean and dry area, do a good job of dust control measures. Tube fittings should be protected during transportation and should not deface the fittings. Pipe fittings packaging can not be directly contacted by hand, should wear clean and clean gloves.
Acceptance requirements: fittings should show purple copper color or white bright color after chemical cleaning. The surface should be bright, there should be no oxidized skin inside or outside. Appearance before packaging full inspection, serious damage, deformation, rupture should be removed; chemical cleaning of the surface of the pipe fittings after the acidity of the available PH wide range of test paper test, copper fittings should be neutral. The pipe fittings which are not qualified in the inspection are placed separately, to be judged out of the processing.







