Gnee Steel (Tianjin) Co., Ltd.

Corrosion resistance of titanium and its principles

Mar 28, 2025

Titanium is known for its excellent corrosion resistance. Although the thermodynamic data for titanium suggests that it is a thermodynamically very unstable metal, titanium actually has excellent corrosion resistance.
If titanium could dissolve to form Ti2+, its standard electrode potential would be very negative (-1.63V). However, the surface of titanium is always covered with an oxide film of passivated titanium, which steadily shifts the stabilizing potential of titanium towards positive values. For example, in seawater at 25°C, the stabilizing potential of titanium is about +0.09V.
The electrode reaction potential data for titanium indicate that its surface is very reactive, but is usually covered with an oxide film. This oxide film is naturally generated in air and is characterized by stability, strong adhesion and protection, which are key factors in determining the excellent corrosion resistance of titanium. Theoretically, the Pilling/Bedworth ratio of the protective oxide film must be greater than 1. The P/B ratio of titanium is between 1 and 2.5 depending on the composition and structure of the oxide film, which makes the oxide film of titanium able to completely cover the metal surface and play a good protective role.

Titanium Sheet MetalIndustrial Titanium platepure titanium plate

When the surface of titanium is exposed to atmosphere or aqueous solution, a new oxide film is generated immediately. For example, in room temperature atmosphere, the thickness of the oxide film is about 1.2~1.6nm and thickens with time. after 70 days, it naturally thickens to 5nm; after 545 days, it gradually increases to 8~9nm. artificially strengthened oxidation conditions (e.g., heating, use of oxidizing agents or anodic oxidation, etc.) can accelerate the growth of the oxide film on the surface and obtain a thicker oxide film, thus improving the corrosion resistance of titanium. Therefore, the oxide film generated by anodic oxidation and thermal oxidation will significantly improve the corrosion resistance of titanium.
The oxide film of titanium (including thermal oxidation film or anodic oxidation film) is usually not a single structure, and the composition and structure of its oxide varies with the generation conditions. In general, TiO₂ may be present at the interface between the oxide film and the environment, however, TiO may dominate at the interface between the oxide film and the metal. In between, there may be transition layers with different valence states, or even non-chemical equivalent oxides, which suggests that there is a multilayer structure in the oxide film of titanium. As for the process of generation of this oxide film, it cannot be simply understood as the result of direct reaction between titanium and oxygen.

goTop