CuBe2Pb ( CW102C )
| Grade : | CuBe2Pb |
| Number: | CW102C |
| Classification: | Low alloyed copper alloy |
| Density | 8.3 g/cm ³ |
| Standard: | EN 12164: 1998 Copper and copper alloys. Rod for free machining purposes EN 12166: 1998 Copper and copper alloys. Wire for general purposes |
| Equivalent grades: | Go here |
Chemical composition % of grade CuBe2Pb ( CW102C )
| Fe | Ni | Co | Pb | Be | Others | - |
| max 0.2 | max 0.3 | max 0.3 | 0.2 - 0.6 | 1.8 - 2 | total 0.5 | Cu - remainder |
Mechanical properties of grade CuBe2Pb ( CW102C )
| Rm - Tensile strength (MPa) (R410) | 410 |
| Rm - Tensile strength (MPa) (R620) | 620 |
| Rp0.2 0.2% proof strength (MPa) (R410) | 190 |
| Rp0.2 0.2% proof strength (MPa) (R620) | 600 |
| A - Min. elongation at fracture (%) (R410) | 20 |
| A - Min. elongation at fracture (%) (R620) | 8 |
| A - Min. elongation Lo = 100mm (%) (R410) | 12 |
| A - Min. elongation Lo = 100mm (%) (R620) | 4 |
| Brinell hardness (HB): (R410) | 120 |
| Brinell hardness (HB): (R620) | 210 |
Equivalent grades of grade CuBe2Pb ( CW102C )
Warning! Only for reference
| EU EN |
Germany DIN,WNr |
||
| CuBe2Pb |
|
Casting process
| GS | Sand casting |
| GM | Permanent mould casting |
| GZ | Centrifugal casting |
| GC | Continuous casting |
| GP | Pressure die casting |
Material conditions
| R | Material condition designated by the minimum value of tensile strength requirement for the product with mandatory tensile strength and elongation requirements |
| H | Material condition designated by the minimum value of hardness requirement for the product with mandatory hardness requirements |
Mechanical properties
| ReH | Minimum yield strength / Mindestwert der oberen Streckgrenze / Limite d elasticite minimale |
| Rm | Tensile strength / Zugfestigkeit / Resistance a la traction |
| A | Minimum elongation / Mindestwert der Bruchdehnung / Allongement minimal |
| J | Notch impact test / Kerbschlagbiegeversuch / Essai de flexion par choc |
|
CuBe2Pb ( CW102C ) Low alloyed copper alloy |
