CuZn23Al3Co ( CW703R )



| Grade : | CuZn23Al3Co |
| Number: | CW703R |
| Classification: | Cupper alloy |
| Density | 8.2 g/cm ³ |
| Standard: | EN 1654: 1998 Copper and copper alloys. Strip for springs and connectors |
| Equivalent grades: | No information |
Chemical composition % of grade CuZn23Al3Co ( CW703R )
| Fe | Ni | Co | Al | Cu | Pb | Sn | Others | - |
| max 0.05 | max 0.3 | 0.25 - 0.55 | 3 - 3.8 | 72 - 75 | max 0.05 | max 0.1 | total 0.1 | Zn - remainder |
Mechanical properties of grade CuZn23Al3Co ( CW703R )
| Rm - Tensile strength (MPa) (R660) | 660-750 |
| Rm - Tensile strength (MPa) (R740) | 740-830 |
| Rp0.2 0.2% proof strength (MPa) (R660) | 580 |
| Rp0.2 0.2% proof strength (MPa) (R740) | 660 |
| A - Min. elongation Lo = 50mm (%) (R660) | 8-10 |
| A - Min. elongation Lo = 50mm (%) (R740) | 3 |
| Vickers hardness ( HV): (H190) (R660) | 190 - 220 |
| Vickers hardness ( HV): (H210) (R740) | 210 - 240 |
Properties CuZn23Al3Co
| Modulus of elasticity = 115 kN/mm ² Electrical conductivity = 10 MS/m; |
Casting process
| GS | Sand casting |
| GM | Permanent mould casting |
| GZ | Centrifugal casting |
| GC | Continuous casting |
| GP | Pressure die casting |
Material conditions
| R | Material condition designated by the minimum value of tensile strength requirement for the product with mandatory tensile strength and elongation requirements |
| H | Material condition designated by the minimum value of hardness requirement for the product with mandatory hardness requirements |
Mechanical properties
| ReH | Minimum yield strength / Mindestwert der oberen Streckgrenze / Limite d elasticite minimale |
| Rm | Tensile strength / Zugfestigkeit / Resistance a la traction |
| A | Minimum elongation / Mindestwert der Bruchdehnung / Allongement minimal |
| J | Notch impact test / Kerbschlagbiegeversuch / Essai de flexion par choc |
|
CuZn23Al3Co ( CW703R ) Cupper alloy |







