Gnee Steel (Tianjin) Co., Ltd.

Bronze Graphite Self-Lubricating Bushings — Materials, PV Ratings & Applications

May 27, 2024

1. Construction and Materials

The bushing is machined from continuous-cast bronze with graphite plugs (cylindrical solid-lubricant inserts) pressed into drilled holes in the bearing surface. Common base alloys:

Base Alloy Composition Characteristic
C93200 (SAE 660) Cu-Sn-Zn-Pb General-purpose, good conformability
C93700 (high-lead tin bronze) Cu-Sn-Pb Heavy-load, high-speed boundary service
C95400 (aluminum bronze) Cu-Al-Fe High strength, high temperature, wear

Graphite plug size (φ3-10 mm typical) and area coverage (5-25%) are selected by load and duty; more plugs for higher loads, larger plugs for heavy wear.

 

2. Self-Lubrication Mechanism

As the shaft starts, graphite transfers a solid lubricant film onto the shaft surface; subsequent motion rides on graphite-on-graphite contact, eliminating metal-to-metal wear. No re-lubrication is needed in service, although life extends if initial running-in is done with a light oil/grease film. Graphite provides dry lubrication to about 300-400°C (higher with special grades), in vacuum, underwater, and in dusty environments where oil would attract contamination.

Copper plumbingcopper pipeOxygen-free Copper bars

3. Design Limits

PV rating: design pressure × sliding velocity must stay below the material PV limit (e.g. ~1.0-2.5 MPa·m/s for graphite-plugged bronze in dry service; higher with lubrication);

Surface pressure: up to about 50-100 MPa for aluminum-bronze bases at low speed;

Speed: suited to low speeds and oscillating/start-stop motion; not for high-speed continuous rotation without lubrication;

Shaft: hardened steel (≥45 HRC) with Ra 0.4-1.6 µm surface for longest life.

 

4. Installation

Press-fit or mechanical retention per application; ensure the graphite plugs align with the load zone when directional;

Bore finish Ra 1.6-3.2 µm; running clearance per shaft size and thermal expansion;

Apply lubricant during initial operation for running-in only;

For submerged or wash-down duty, choose corrosion-resistant bases (C95400) and sealed end faces.

 

5. Applications

Steel-mill equipment, furnace door rollers, drying and roasting equipment, heat exchangers, stamping dies, machine tools, chain conveyors, offshore cranes and winches, hatch covers, rudder and lifting gear, injection-moulding machines, mixers, grinders, mining shovels and construction machinery - anywhere relubrication is difficult or oil/grease is unacceptable.

goTop