CuZn0.5 ( CW119C )


| Grade : | CuZn0.5 |
| Number: | CW119C |
| Classification: | Cupper alloy |
| Density | 8.9 g/cm ³ |
| Standard: | EN 1652: 1998 Copper and copper alloys. Plate, sheet, strip and circles for general purposes EN 1172: 1997 Copper and copper alloys. Sheet and strip for building purposes EN 13148: 2001 Copper and copper alloys. Hot-dip tinned strip |
| Equivalent grades: | Go here |
Chemical composition % of grade CuZn0.5 ( CW119C )
| P | Zn | Others | - |
| max 0.02 | 0.1 - 1 | total 0.1 | Cu - remainder |
Mechanical properties of grade CuZn0.5 ( CW119C )
| Rm - Tensile strength (MPa) (R220) | 220-260 |
| Rm - Tensile strength (MPa) (R240) | 240-300 |
| Rm - Tensile strength (MPa) (R290) | 290-360 |
| Rp0.2 0.2% proof strength (MPa) (R220) | 140 |
| Rp0.2 0.2% proof strength (MPa) (R240) | 180 |
| Rp0.2 0.2% proof strength (MPa) (R290) | 250 |
| A - Min. elongation at fracture (%) (R220) | 42 |
| A - Min. elongation at fracture (%) (R240) | 15 |
| A - Min. elongation at fracture (%) (R290) | 6 |
| A - Min. elongation Lo = 50mm (%) (R220) | 33 |
| A - Min. elongation Lo = 50mm (%) (R240) | 8 |
| Vickers hardness ( HV): (H040) | 40 - 65 |
| Vickers hardness ( HV): (H065) | 65 - 95 |
| Vickers hardness ( HV): (H085) | 85 - 115 |
Equivalent grades of grade CuZn0.5 ( CW119C )
Warning! Only for reference
| EU EN |
Germany DIN,WNr |
||
| CuZn0.5 |
|
Casting process
| GS | Sand casting |
| GM | Permanent mould casting |
| GZ | Centrifugal casting |
| GC | Continuous casting |
| GP | Pressure die casting |
Material conditions
| R | Material condition designated by the minimum value of tensile strength requirement for the product with mandatory tensile strength and elongation requirements |
| H | Material condition designated by the minimum value of hardness requirement for the product with mandatory hardness requirements |
Mechanical properties
| ReH | Minimum yield strength / Mindestwert der oberen Streckgrenze / Limite d elasticite minimale |
| Rm | Tensile strength / Zugfestigkeit / Resistance a la traction |
| A | Minimum elongation / Mindestwert der Bruchdehnung / Allongement minimal |
| J | Notch impact test / Kerbschlagbiegeversuch / Essai de flexion par choc |
|
CuZn0.5 ( CW119C ) Cupper alloy |







