Straight pipe stretching methods and characteristics



Common straight drawing methods for copper alloy pipes include fixed core stretching, moving core stretching, long core rod stretching, pipe jacking, diameter expansion and empty drawing.
(1) Stretch the fixed core head. It is a commonly used pipe stretching method. During stretching, the core rod with the core head is fixed and inserted into the pipe blank, and the diameter and wall of the pipe are reduced through the die hole. Since the contact friction area is large in this stretching method, the pass processing rate is small. In addition, due to the influence of the length of the core rod and its own weight, it is difficult to produce longer pipes. And because the core rod has a large elastic elongation when stretched, it can easily cause "jumping" and "bamboo knots" appear on the pipe.
(2) The swimming core head is stretched. It is also a commonly used pipe stretching method. When stretching, since the core head has a tapered surface and a cylindrical surface, the force on the core head is in a balanced state. It is very suitable for stretching long straight pipes and coiled pipes. It is a relatively advanced stretching method in pipe stretching. . It has high productivity, high yield, good inner surface quality of pipes, and is currently the most widely used.
(3) Long core rod stretching. It is a method in which the tube blank is placed on a long core rod, and the core rod passes through the die hole along with the tube blank during stretching to achieve diameter and wall reduction. Since the direction of friction between the inner wall of the tube and the core rod is the same as the direction of stretching, the pass processing rate is large. However, special equipment must be used to remove the pipe from the core rod, which adds a lot of auxiliary time. It is suitable for stretching thin-walled large pipes and pipes with poor plasticity.







